Should I remove the plastic covering the ink cartridge hole?
No! There is no need to remove this plastic piece unless there is a pull tab attached to it.
Once you've installed the cartridge, the printer will pierce a hole through it, allowing ink to flow through.
Please email support@inkstation.com.au if you would like to confirm what needs to be removed for your cartridge.
Related Articles
My new ink jet cartridge is having print quality issues.
If you're experiencing print quality issues, please try the below steps to see if there are any improvements. Check for any tabs or stickers that need to be removed. These tabs are usually yellow or red and are marked. Make sure there is enough ink ...
My printer is not recognising the cartridge. What can I do?
When installing cartridges be sure to remove any tabs, wedges or covers that are on the inkjet / toner. Do not pierce or remove the the plastic covering where the ink is released. If all appropriate parts are removed and the cartridge still not ...
My new toner cartridge is not printing properly.
If you're having print quality issues with a toner, please try the following to see if the quality improves Gently shake the cartridge side to side so the toner is evenly distributed. We recommend doing this over a sink or some newspaper as some ...
Should I pull out the plastic strip in my toner?
Most of the time, these plastic strips are there to prevent leakage during transit. They run the length of the toner and will need to be removed so the toner can come out during printing. There should be an instruction leaflet enclosed with the ...
My cartridge is still reading low or empty after installing a new cartridge.
Genuine For all genuine cartridges that do not have the correct ink levels, please contact your printer's manufacturer to troubleshoot. Compatible Ink Station cartridges are manufactured by a combination or new and re-manufactured parts. Cartridges ...